Pure Pull Installation Instructions

1. Open door and secure.
2. Tape drill pattern to door
3. Center 1/8th” bit and drill through all 4 openings.
4. Repeat with 3/16th” bit
5. Repeat with ¼” bit
6. Repeat with ⅜” bit
7. REMOVE PATTERN
8. Line up end plate to make certain it is level
9. Drill all 4 holes with ½” bit
10. Insert hex nuts into prolonged plate
11. Insert prolonged plate into holes
12. Insert screws into handle and screw to hex nuts
13. And washer, end cap, and tighten
14. Clean floor area
15. Post “STOP” labels on inside and outside door
16. Post plasticized flyer on mirror
17. Collect payment or leave bill